Amerex 05605 Instrukcja Użytkownika

OWNERS SERVICE MANUAL NO. 05605 INSTALLATION, OPERATING & SERVICING INSTRUCTIONS Wheeled Models 450, 451, 452 ( 25 Cu. Ft. Nitrogen C

9 b. Carefully tip extinguisher over until it rests on both wheels and handle. (In this position much of the agent will remain in the cylinder). c.

10 TROUBLESHOOTING GUIDE WARNING: BEFORE ATTEMPTING TO CORRECT ANY LEAKAGE PROBLEM, BE SURE THAT THE AGENT CYLINDER IS COMPLETELY DEPRESSURIZED.

11 Guide to Proper Installation of Hose on Wheeled or Stationary Fire Extinguishers 1 Connect hose coupli

12 PARTS LIST for 125/150 lb. Wheeled & Stationary Dry Chemical Extinguishers 110 Cu. Ft. Nitrogen Cylinder WHEELED MODELS 467 125 LB. A

13 PARTS LIST for 125/150 lb. Wheeled & Stationary Dry Chemical Extinguishers 23 Cu. Ft. Nitrogen Cylinder WHEELED MODELS STATIONARY MODELS

1 INTRODUCTION PREPARING YOUR NEW EXTINGUISHER FOR USE WARNING: THIS FIRE EXTINGUISHER IS SHIPPED FROM THE FACTORY EMPTY. AFTER INITIAL PREPARA

2 INSTALLATION WARNING: DO NOT PLACE THIS EXTINGUISHER CLOSE TO A POTENTIAL FIRE Do not place this extinguisher close to a potential fire hazard.

3 VENTING DEVICE (Standard on all Stationary Extinguishers, Optional on Wheeled Extinguishers) A venting device has been installed on all stationary

4 INSPECTING THE EXTINGUISHER PERIODIC INSPECTION PROCEDURES (Monthly or more often if circumstances dictate) A “quick check” should be made of

5 ANNUAL MAINTENANCE – SERVICE PROCEDURE WARNING: BEFORE SERVICING, BE SURE THE EXTINGUISHER AGENT CYLINDER IS NOT PRESSURIZED. THIS PROCEDURE IS

6 MAINTENANCE OF REGULATED WHEELED EXTINGUISHERS NOTE: Steps R-a thru R-d apply to models with a Regulator. These procedures should be performed

7 e. Operate the nozzle lever to ensure proper operation and to clear the hose of any obstructions (if hose is obstructed – refer to Troubleshooting

8 13. Disconnect the high pressure hose from the argon cylinder valve. Securely install the service kit Argon/Nitrogen Cylinder Pressure Check Gaug